Welcome to the Rust ESP Development board project. This repository contains everything you will need to build the board yourself. Manufactured boards will be available soon, at which point a purchase link will replace this text.

• ESP32-C3-DevKit-RUST-1
• AliExpress Espressif Official Store

• Training: Explore the power of Rust on the new Espressif board

This board is based on the ESP32-C3, and includes sensors, LEDs, buttons, a battery charger, and USB type-C connector.

• IEEE 802.11 b/g/n-compliant
• Bluetooth 5, Bluetooth mesh
• 32-bit RISC-V single-core processor, up to 160MHz
• 384 KB ROM
• 400 KB SRAM (16 KB for cache)
• 8 KB SRAM in RTC
• 22 × programmable GPIOs
• 3 × SPI
• 2 × UART
• 1 × I2C
• 1 × I2S
• 2 × 54-bit general-purpose timers
• 3 × watchdog timers
• 1 × 52-bit system timer
• Remote Control Peripheral (RMT)
• LED PWM controller (LEDC)
• Full-speed USB Serial/JTAG controller
• General DMA controller (GDMA)
• 1 × TWAI®
• 2 × 12-bit SAR ADCs, up to 6 channels
• 1 × temperature sensor

For the complete description, see the ESP32-C3 Datasheet.

This board includes the following peripherals over the I2C bus:

The following devices are connected through GPIO:

• USB type-C (no PD compatibility).
• Li-Ion battery charger.

• [1] Connected to LDO enable pin*
• [2] Connected to USB 5V*

• ESP32C3

Top

Bottom

Interactive BOM